M3 type trunk spoiler suitable for BMW 3 Series E90 2005-2011, unpainted

BMW 3 Sedan (E90) (2005-2008)

DescriptionAdding a rear spoiler is one of the ways in which the car manufacturer distinguishes sports models from regular base models. However this spoiler usually comes with a larger engine lower fuel consumption larger tires tuning grilles and higher replacement costs etc. Factory models definitely have their appeal especially from a financial perspective. But just because you've saved money doesn't mean you can't have style. A rear tuning spoiler will make your ride look like a tuning model but for much less money! With us you will find a wide variety of spoilers suitable for brands like Audi BMW Mercedes Volkswagen Tesla Honda and Lexus. Each spoiler is carefully packaged and shipped with express delivery! The spoiler is an accessory that improves the aerodynamics of the vehicle. Spoilers have positive properties regarding stability and handling of the vehicle at high speeds. With a spoiler present the car's tendency to skid in a turn is reduced. This happens due to the altered airflows acting on the vehicle during motion. When it comes to aesthetic functions an important aspect is the final finished look of the vehicle - this will give your car a sportier appearance. According to aerodynamic specialists the properties of the spoiler mounted on the trunk are activated at speeds above 80 km/h. The airflow passing through the spoiler creates a downforce effect meaning pressure is exerted on the rear of the vehicle. Before all of the above it is necessary to paint the spoiler as many trunk spoilers come with only a factory-applied base. Exceptions are spoilers that are already painted! Trunk tuning spoilers are one of the quickest ways to improve the aerodynamics and appearance of the vehicle. Installing the spoilers we offer at AB.bg is significantly easy and quick! It is recommended that the spoilers be installed when the outside temperature is above 15-20°C for maximum effect. This temperature is necessary because the spoilers are secured using a high-elastic double-sided adhesive tape that is specially designed. To start the trunk lid must be thoroughly cleaned using a cleaning agent or shampoo. Then it is necessary to dry the area well. It is advisable to additionally treat the trunk with isopropyl alcohol to remove greasy residues that may hinder the perfect adhesion of the mounting tape or silicone. Position the spoiler at equal distances from the left and right sides of the trunk to achieve the most accurate symmetry. Make marks with masking tape or another material where the spoiler fits to serve as a guide. Place the double-sided tape on the spoiler. Heat-resistant silicone can also be used. IT IS VERY IMPORTANT not to seal the ventilation holes (small holes in the spoiler) with tape or silicone! Place the spoiler on the trunk peeling off about 2-3 cm of the double-sided tape beforehand pulling it so that the peeled end sticks out to the side. This is done from both ends of the tape. However if you have used more than one tape you should peel off approximately 2-3 cm from each one. Use the guide marks or points to position the spoiler correctly. When you are sure the spoiler is positioned correctly start carefully peeling off the tapes holding them by the protruding ends you left from step 5. After you have peeled off all the tapes apply light pressure on the spoiler towards the trunk to ensure it is evenly adhered everywhere. Remove the guide points and place masking tape at both ends of the spoiler to apply pressure for a while. This is done when using silicone. **Manufacturers recommend that the vehicle not be used for at least 12 hours and not be exposed to water. This recommendation is to ensure everything adheres properly. If the entire procedure seems complicated or you simply want professional installation you can book an appointment for installation at our auto service AB.